SCCA American Sedan AS Race Car

SCCA American Sedan AS Race Car

 

CAMARO Race CAR lots of parts and extra block and heads. This car started life as a light weight 1982 Camaro which was stripped to the shell and then all parts from a 1989 1LE Iroc where put on it. SCCA AS / ITE American Sedan Camaro Great car for track days or SCCA racing or Club racing , 6 point welded cage with NASCAR Bars, aluminum seat, NEW Camlock TRW Belts, NEW Steering Wheel ,1LE Corvette style Aluminum PBR front and rear brakes calipers, serpentine belt setup, Griffin radiator, long wheel studs, 10 bolt rear, 4 weight jackers (makes raising and lowering very fast), Muncie M21 t-10 trans, 350 chevy motor which has As Legal Edelbrock intake and Holley Carb. supertrap muffler, new stainless fuel lines with AN fittings, 22 gallon fuel cell, Inside has been repainted with rubberized paint, roll cage has been repainted, there is new padding on roll cage, new Holley electric fuel pump. Body is in fair shape with the average road racing dents and marks, Lots of new parts for this car. If you have any questions email me. Comes with scca logbook

LOTS OF SPARES Group 1:

  • 2 pairs of front spindels
  • 3 extra sets of iroc wheels (1 set on car)
  • lots of gaskets (head , intake, etc.)
  • many sets of new and used lug nuts.
  • 2 10 bolt rear end covers.
  • 2 new front rotors
  • 1 pairs HAWK blue pads NEW (cost 200.00 a pair new)
  • 2 Pairs slight used
  • 2 pairs carbotech new pads
  • 2 PBR front calipers
  • 2 rear 1LE calipers
  • 1 pair front blue coil springs NEW
  • 1 pair front blue coil springs used
  • 1 pair rear blue coil springs new
  • 1 pair rear blue coil springs used
  • 1 used steering box and steering linkage.
  • 1 lower A-Arm
  • 2 trailing arms
  • 1 Set hood hinges
  • Box of Carb jets
  • Rear Glass
  • 1 rear deck lid
  • 1 left front fender (to replace the one on the car that has a few dings)
  • 2 new stute mounts
  • 1 set rear tail lights nice shape no cracks
  • extra serpentine pulley brackets and parts
  • the following is parts to build a AS engine: 1 set of stock correct heads casting number 14014416. Correct modern 305 block with crank stock rods and Pistons.

    Extra Spares Group 2
  • 1 Set new slotted 1Le front rotors $175.00
  • 1 1Le Aluminum Drive Shaft $150.00
  • 1 set rear 1Le calipers and mount plates (almost new) $275.00
  • Aussie 9 bolt Rear end with 3:08 gear $500.00
  • 1 set of new in the box correct Eagle Rods $300.00
  • 1 1Le Iroc Wonder bar $ 75.00
  • New SLP lower control arms with harder bushings $125.00
  • 1 set of modern correct 305 heads, built up stainless valves, guide plates rew in studs, all new $725.00 rare heads
  • 1 road race oil pan trap doors with pickup. $250.00

    Price:
    Just car minus engine and trans (no spares) $ 3,950.00
    Car Minus Engine and Trans but with group 1 spares $ $6,950.00
    Complete car and all spares in group 1 $8,750.00
    Complete car and all the spares I have group1 and 2 $11,300.00

    Phone: (314) 843-4238
    e-Mail: lorenz21@swbell.net

     

    click here to return to the SCCA (AS) main page.

















  •   

      





    The Racers Network™ holds no responsibility for the Information displayed on this site.
    All copyrights and trademarks are owned by and are the property of The Racers Network™ and Walco USA™

    Software by Walco USA™ all rights reserved
    A Walco USA Corporation Company